This product is intended for expert users only. Please consult with a qualified technician for installation. Improper installation may result in
damage to your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of these products, nor their
installation. The following instructions are subject to change without notice. Please visit our web site at www.swiftnets.com
for updates.
Setup diagram for nVidia® GeForce 6800 and GeForce 7 series adapters
ITEM NO. PART NUMBER DESCRIPTION QTY.
1MCW55 Waterblock 1
3 92196A106 4-40 x 1/4" S/S socket screw 2
6 1-2inch-collet Quick-connect collet 2
7 NV70 VGA adapter 1
8 bracket-NV40 Water-block hold-down plate 1
9 MCW55-CROSS-bracket-G70 Back plate 1
11 SCREW INSULATOR10SC004025 Nylon tension limiter 4
12 70700S spring 4
13 Stem plug Rubber plug 1
14 M2-5x27mm Metric screws 4
Pull-out these 2 collets
installing the hold-down bracket 8.
Then snap them back into place.
prior to
Installation sequence:
1. Temporarily fasten 2 diagonal screws
their springs and washers. This
will conveniently align back-plate 9
with hold-down plate 8.
2. Then Install the other 2 screws with
their springs and washers as shown in
this schematic, and tighten them half way.
3. Remove the first two screws,
and re-install them with their springs
and washers and tighten half-way.
4. Complete tightening all four
screw-spring assemblies in a cross
pattern.
without
14
11
12
8
6
7
9
13
2
Figure 1
Copyright Swiftech 2005 – Subject to revision without notice - Revision date: 9-15-05
Swiftech Inc., 1703 E. 28
th
St., Signal Hill, CA 90755 T. (562) 595-8009 F. (562) 595-8769
Page 1 of 2
Kommentare zu diesen Handbüchern